D-Link xStack DGS-3620 Reference Manual page 791

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
all - Specifies to configure all VLANs.
state - Enable or disable MLD snooping for the chosen VLAN.
enable - Enable MLD snooping for the chosen VLAN.
disable - Disable MLD snooping for the chosen VLAN.
topology_changes_notification - Specifies that MLD snooping should be aware of link-layer
topology changes caused by the Spanning Tree operation or not.
ignore - Specifies that MLD snooping will ignore link-layer topology changes caused by the
Spanning Tree operation. The General Query won't be sent on the same domain of link-
layer topology changes.
process - Specifies that MLD snooping will process link-layer topology changes caused by
the Spanning Tree operation. The General Query will be sent on the same domain of link
layer topology changes.
fast_done - Enable or disable the MLD snooping fast leave function. If enabled, the membership
is immediately removed when the system receive the MLD leave message.
enable - Enable the MLD snooping fast leave function.
disable - Disable the MLD snooping fast leave function.
proxy_reporting - Specifies that the proxy reporting function will be configured.
state - Specifies the state of the proxy reporting function.
enable - Specifies that the proxy reporting function will be enabled.
disable - Specifies that the proxy reporting function will be disabled.
source_ip - Specifies the source IPv6 address used.
<ipv6addr> - Enter the source IPv6 address used here.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure MLD snooping:
DGS-3620-28PC:admin#config mld_snooping vlan_name default state enable
Command: config mld_snooping vlan_name default state enable
Success.
DGS-3620-28PC:admin#
68-2 config mld_snooping rate_limit
Description
This command is used to configure the upper limit per second for ingress MLD control packets.
Format
config mld_snooping rate_limit [ports <portlist> | vlanid <vlanid_list>] [<value 1-1000> |
no_limit]
Parameters
ports - Specifies a range of ports to be configured.
<portlist> - Enter a range of ports to be configured.
vlanid - Specifies a range of VLANs to be configured.
<vlanid_list> - Enter the VLAN ID list.
786