Enable Bgp; Disable Bgp - D-Link xStack DGS-3620 Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
<network_address>] | ipv6 unicast {[<ipv6addr> | <ipv6_networkaddr>]}]}
12-1

enable bgp

Description
This command is used to enable the BGP protocol. By enabling the BGP protocol, all the previous
configurations will be applied to the protocol kernel and start. By default, BGP is disabled.
Format
enable bgp
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command. (EI Mode Only
Command)
Example
To enable BGP protocol:
DGS-3620-28PC:admin# enable bgp
Command: enable bgp
Success.
DGS-3620-28PC:admin#
12-2

disable bgp

Description
This command is used to disable the BGP protocol. By disabling the BGP protocol, all peers will be
disconnected and dynamic routes will be deleted. All the static configurations however will be
reserved. If BGP enables again, the previous configurations can be re-applied.
Format
disable bgp
Parameters
None.
167