D-Link xStack DGS-3620 Reference Manual page 343

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
DGS-3620-28PC:admin# debug bgp show peer_group
Command: debug bgp show peer_group
BGP Peer Group :tt
-------------------------------------------------------
Session State : Enabled
Session Activity : Enabled
Members : None
Remote AS : Not Set
Holdtime Interval : 180 seconds
Keepalive Interval : 60 seconds
Advertisement Interval : 0 seconds
AS Origination Interval : 0 Seconds
Connect Retry Interval : 0 Seconds
EBGP Multihop : 1
Weight : 0
Next Hop Self : Disabled
Remove Private As : Disabled
Allowas In : Disabled
Soft Reconfiguration Inbound : Disabled
Community Sent to this Neighbor : None
Default Originate : Disabled
Capability 0rf Prefix List : None
Pass Word:
Prefix Max Count: 12000
Prefix Warning Threshold: 75
Prefix Max Warning: Disabled
DGS-3620-28PC:admin#
20-45 debug bgp show network
Description
This command is used for displaying current network's configuration in BGP protocol stack.
Format
debug bgp show network {ipv6 unicast}
Parameters
ipv6 unicast – (Optional) Specifies to debug the IPv6 unicast address family.
Restrictions
Only Administrator-level users can issue this command. (EI Mode Only Command)
Example
Configure BGP to show network information:
338