D-Link xStack DGS-3620 Reference Manual page 866

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Parameters
None.
Restrictions
None.
Example
To display the syslog source interface:
DGS-3620-28PC:admin#show syslog source_ipif
Command: show syslog source_ipif
Syslog Source IP Interface Configuration:
IP Interface
IPv4 Address
IPv6 Address
DGS-3620-28PC:admin#
74-21 show attack_log
Description
This command is used to display the switch's attack log.
Format
show attack_log {unit <unit_id 1-12>} {index <value_list>}
Parameters
unit - (Optional) Specifies the switch unit used.
<unit_id 1-12> - Enter the switch unit ID here. This value must be between 1 and 12. If unit ID
is not specified, then this unit will be referred to as the master unit.
index - (Optional) Specifies the list of index of the entries that need to be displayed.
<value_list> - Enter the list of index of the entries that need to be displayed. For example,
show attack_log index 1-5 will display the attack log messages from 1 to 5.
Note: If no parameter is specified, all entries in the attack log will be displayed.
Restrictions
None.
Example
To display the switch's attack log:
: System
: None
: None
861