D-Link xStack DGS-3620 Reference Manual page 303

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
debug bgp show network {ipv6 unicast}
debug bgp show aggregate {ipv6 unicast}
debug bgp show damp {ipv6 unicast}
debug bgp show interface_info
debug bgp show as_path_access_list
debug bgp show bgp_timer
debug bgp show community_list
debug bgp show redist_info
debug bgp router_map [enable | disable]
debug bgp access_list [enable | disable]
debug bgp prefix_list [enable | disable]
debug bgp state [enable | disable]
debug dhcpv6_client state enable
debug dhcpv6_client state disable
debug dhcpv6_client output [buffer | console]
debug dhcpv6_client packet {all | receiving | sending} state [enable | disable]
debug dhcpv6_relay state enable
debug dhcpv6_relay state disable
debug dhcpv6_relay hop_count state [enable | disable]
debug dhcpv6_relay output [buffer | console]
debug dhcpv6_relay packet {all | receiving | sending} state [enable | disable]
debug dhcpv6_server packet [all | receiving | sending] state [enable | disable]
debug dhcpv6_server state disable
debug dhcpv6_server state enable
debug pim ssm
no debug pim ssm
debug ripng flag [{interface | packet [all | rx | tx] | route} | all] state [enable | disable]
debug ripng show flag
debug ripng state disable
debug ripng state enable
debug routefilter show [prefix_list | access_list | route_map | ipv6_prefix_list | ipv6_access_list]
debug show status {module <module_list>}
debug super_vlan state [enable | disable]
debug show address_binding binding_state_table [nd_snooping | dhcpv6_snooping]
debug show error ports box_id [<value 1-12> | all] {sio1 | sio2}
debug show jwac auth_info
debug show packet ports box_id [<value 1-12> | all] {sio1 | sio2}
debug show cpu utilization
20-1 debug address_binding
Description
This command is used to start the IMPB debug when the IMPB module receives an ARP/IP packet
or a DHCP packet.
Format
debug address_binding [event | dhcp | all] state [enable | disable]
Parameters
event - To print out the debug messages when IMPB module receives ARP/IP packets.
dhcp - To print out the debug messages when the IMPB module receives the DHCP packets.
all - Print out all debug messages.
298