Switches - Xilinx KCU105 User Manual

Default Switch and Jumper Settings
The default switch and jumper settings for the KCU105 evaluation board are provided in this
appendix.

Switches

The default switch settings are listed in
Table A-1: Default Switch Settings
Switch Function
SPST SLIDE SWITCH
SW1
SW12 4-POLE GPIO DIP (1)
6-POLE CONFIGURATION DIP (1)
SW15
SW15 6-POLE CONFIGURATION DIP (1)
Notes:
1. DIP switches are active High (connected net is pulled High when DIP switch is closed).
KCU105 Board User Guide
UG917 (v1.4) September 25, 2015
Table A-1.
Default Comments
BOARD SHIPPED WITH POWER
OFF
SW. OFF
0000 POS. 1-4 GPIO ACTIVE HIGH
POS. 1-5 ZYNQ SYSTEM CTLR.
00000
U111
0 POS. 6 FPGA U1 MODE M2
www.xilinx.com
Appendix A
Schematic
Figure 1-2
0381556
Callout
Page
30 51
26 41
28 32
28 32
88
Send Feedback