Removing The Size 3 And 4 Dc Terminal Cover Break-Outs - Emerson Powerdrive F300 User Manual

Safety Product Mechanical Electrical Getting Basic Running NV Media Card Onboard Advanced Technical UL listing
Optimization Diagnostics
information information installation installation started parameters the motor Operation PLC parameters data information
Figure 3-11 Removing the size 3 and 4 DC terminal cover break-outs
Grasp the DC terminal cover break-outs with pliers as shown (1) and pull
down in the direction shown to remove. Continue until all required break-
outs are removed (2). Remove any flash / sharp edges once the break-
outs are removed. Use the DC terminal cover grommets supplied in the
accessory box (Table 2-9 on page 20) to maintain the seal at the top of
the drive.
29
Powerdrive F300 User Guide
Issue Number: 2