Onboard Plc Parameters - Emerson Powerdrive F300 User Manual

Safety Product Mechanical
information information installation
10.4

Onboard PLC parameters

The following parameters are associated with the Onboard PLC user
program.
11.047 Onboard User Program: Enable
RW Txt
Stop (0) or Run (1)
This parameter stops and starts the user program.
0 - Stop the User Program
The onboard user program is stopped. If it is restarted by setting
Onboard User Program: Enable (11.047) to a non-zero value the
background task starts from the beginning.
1 - Run the User Program
The user program will execute.
11.048 Onboard User Program: Status
RO Txt
-2147483648 to
2147483647
This parameter is read-only and indicates the status of the user program
in the drive. The user program writes the value to this parameter.
0: Stopped
1: Running
2: Exception
3: No user program present
11.049 Onboard User Program: Programming Events
RO Uni
0 to 65535
This parameter holds the number of times an Onboard PLC user
program download has taken place and is 0 on dispatch from the factory.
The drive is rated for one hundred ladder program downloads. This
parameter is not altered when defaults are loaded.
Onboard User Program: Freewheeling Tasks Per
11.050
Second
RO Uni
0 to 65535
This parameter shows the number of times the freewheeling task has
started per second.
11.051 Onboard User Program: Clock Task Time Used
RO
0.0 to 100.0 %
This parameter shows the percentage of the available time used by the
user program clock task.
168
Electrical Getting Basic
installation started parameters
US
Run (1)
NC PT
NC PT PS
NC PT
NC PT
Running NV Media Card
Optimization
the motor Operation
11.055
RO
0 to 262128 ms
This parameter shows the interval at which the clock task is scheduled to
run at in ms.
If the drive detects an error in the user program it will initiate a User
Program trip. The sub-trip number for the User Program trip details the
reason for the error. See Chapter 13 Diagnostics on page 260 for more
information on the User Program trip.
Onboard Advanced Technical
PLC parameters data
Onboard User Program: Clock Task Scheduled
Interval
NC PT
Powerdrive F300 User Guide
UL listing
Diagnostics
information
Issue Number: 2