Removing The Finger-Guard And Dc Terminal Cover Break-Outs - Emerson Unidrive M702 User Manual

Safety Product Mechanical
information information installation
3.3.2 Removing the finger-guard and DC terminal
cover break-outs
Figure 3-9 Removing the finger-guard break-outs
A: All sizes
B: Size 5 only
C: Size 6 only
D: Size 7 and 8
Place finger-guard on a flat solid surface and hit relevant break-outs with
hammer as shown (1). Continue until all required break-outs are
removed (2). Remove any flash / sharp edges once the break-outs are
removed.
26
Electrical Getting Basic
installation started parameters the motor
Running NV Media Card
Optimization
Operation
Figure 3-10 Removing the size 3 and 4 DC terminal cover break-outs
Grasp the DC terminal cover break-outs with pliers as shown (1) and pull
down in the direction shown to remove. Continue until all required break-
outs are removed (2). Remove any flash / sharp edges once the break-
outs are removed. Use the DC terminal cover grommets supplied in the
accessory box (Table 2-11) to maintain the seal at the top of the drive.
Onboard Advanced Technical
Diagnostics
PLC parameters data
Unidrive M702 User Guide
UL listing
information
Issue Number: 3