Size 9E And10 Model And Line Reactor Part Number; Input Line Reactor Dimensions - Emerson Powerdrive F300 User Manual

Safety Product Mechanical
information information installation
12.1.22 Protective ground cable ratings
Table 12-22 Protective ground cable ratings
Input phase
conductor size
2
≤ 10 mm Either 10 mm
2 2
The same cross-sectional area as the input phase conductor
> 10 mm and ≤ 16 mm
2 2
> 16 mm and ≤ 35 mm 16 mm
2
Half of the cross-sectional area of the input phase conductor
> 35 mm
12.1.23 Input line reactor specification for size 9E, 10E and 11E
A separate line reactor (INLXXX) of at least the value shown in Table 12-24 and Table 12-23 must be used with size 9E, 10E and 11E.
Failure to provide sufficient reactance could damage or reduce the service life of the drive.
CAUTION
Table 12-23 Size 9E and10 Model and Line reactor part number
Size
09202160, 09202660, 09402210, 09402660
9E
09501250, 09501500, 09601720, 09601970
10203250, 10203600, 10403200, 10403610
10E
11E
11502480, 11502880, 11503150, 11602250, 11602750, 11603050
* Natural cooling.
** May represent a more economic solution where operating temperature and cooling requirements are observed.
*** May represent a more economic solution when operating below 420 A.
Figure 12-1 Input line reactor dimensions
Table 12-24 Input line reactor ratings
Current
Part
Model
number
4401-0181 INL 401
4401-0182 INL 402
4401-0208 INL 401W**
4401-0209 INL 402W**
4401-0274 INL 403L*
4401-0259 INL403*
4401-0183 INL 601
4401-0184 INL 602
4401-0261 INL 603*
* Natural cooling.
** May represent a more economic solution where operating temperature and cooling requirements are observed.
NOTE
If symmetrical fault current exceeds 38 kA then a line reactor with a higher inductance must be used, consult the supplier of the drive.
250
Electrical Getting Basic
installation started parameters
2
or two conductors of the same cross-sectional area as the input phase conductor.
2
Drive model
10502000, 10601720, 10601970
11404370
11404370, 11404870, 11405070
Overall
Inductance
width (W)
μH
A mm
245 63 240
339 44 276
245 63 255
339 44 255
420 30 300
557 30 300
145 178 240
192 133 276
331 93 300
Running NV Media Card
Optimization
the motor Operation
Minimum ground conductor size
H
D
W
Overall Overall
Weight
depth (D) height (H)
mm mm
190 225
200 225
235 200
235 200
216 264
216 264
190 225
200 225
216 264
Onboard Advanced Technical
PLC parameters data
Inductor model Line reactor part number
INL 401
INL 401W**
INL 601
INL 402
INL 402W**
INL 602
INL 403L***
INL 403*
INL 603*
Max
Min
ambient
airflow
temp
kg °C m/s
32 50 1
36 50 1
27 40 3
27 40 3
57 40 0
57 40 0
33 50 1
36 50 1
58 40 0
Powerdrive F300 User Guide
UL listing
Diagnostics
information
4401-0181
4401-0208
4401-0183
4401-0182
4401-0209
4401-0184
4401-0274
4401-0259
4401-0261
Maximum
Quantity
losses
required
W
148 1
205 1
1
1
1
1
88 1
116 1
1
Issue Number: 2