Removing The Finger-Guard And Dc Terminal Cover Break-Outs; Removing The Size 7 To 11 Terminal Covers; Removing The Finger-Guard Break-Outs; Grommet Kits - Emerson Powerdrive F300 User Manual

Safety Product Mechanical
information information installation
Figure 3-9 Removing the size 7 to 11 terminal covers (size 7 shown)
When replacing the terminal covers, the screws should be tightened to a maximum torque of 1 N m (0.7 lb ft).
3.3.2

Removing the finger-guard and DC terminal cover break-outs

Figure 3-10 Removing the finger-guard break-outs
A: All sizes. B: Size 5 only. C: Size 6 only. D: Size 7 to 10.
28
Electrical Getting Basic
installation started parameters the motor
Running NV Media Card
Optimization
Operation
Place finger-guard on a flat solid surface and hit relevant break-outs with
hammer as shown (1). Continue until all required break-outs are
removed (2). Remove any flash / sharp edges once the break-outs are
removed.
Grommet kits are available for size 7 to 10 finger guards. For size 8 to
10, two versions are available allowing for either single or double cable
entries.
Table 3-1 Grommet kits
Drive size
Size 7 - Kit of 8 x
single entry
grommets
Size 8 - Kit of 8 x
single entry
grommets
Size 8 - Kit of 8 x
double entry
grommets
Size 9E and 10E -
Kit of 8 x double
entry grommets
Size 11E- Kit of 8 x
double entry
grommets
Onboard Advanced Technical
Diagnostics
PLC parameters data
Quantity
Part number
of kits
1 3470-0086-00
1 3470-0089-00
1 3470-0090-00
1
3470-0107-00
2
Powerdrive F300 User Guide
UL listing
information
Picture
Issue Number: 2