Removal Of A Standard Option Module; Installation And Removal Of The Ki-Keypad - Emerson Powerdrive F300 User Manual

Safety Product Mechanical
information information installation
Figure 3-13 Removal of a standard option module
• Press down on the tab (1) to release the option module from the drive housing, the tab is highlighted in the detailed view (A).
• Tilt the option module towards you as shown (2).
• Totally remove the option module in direction shown (3).
Figure 3-14 Installation and removal of the KI-Keypad
To install, align the keypad and press gently in the direction shown until it clicks into position.
To remove, reverse the installation instructions.
N
NOTE
The keypad can be installed / removed while the drive is powered up and running a motor, providing that the drive is not operating in keypad mode.
Powerdrive F300 User Guide
Issue Number: 2
Electrical Getting Basic
installation started parameters the motor
Running NV Media Card
Optimization
Operation
Onboard Advanced Technical
Diagnostics
PLC parameters data
UL listing
information
31