Teaching in a program
12.3 Inserting a block
Operating mode or operating area switchover
If you switch to another operating mode or operating area in teach-in mode, the position
changes will be canceled and teach-in mode will be cleared.
12.3
Inserting a block
You have the option of traversing the axes and writing the current actual values directly to a
new position block.
Requirement
"AUTO" mode: The program to be edited is selected.
Proceed as follows
308
1.
Select the "Machine" operating area.
2.
Press the <AUTO> or <MDA> key.
3.
Press the <TEACH IN> key.
4.
Press the "Teach prog." softkey.
5.
Traverse the axes to the relevant position.
6.
Press the "Teach position" softkey.
A new program block with the current actual position values will be cre-
ated.
Operating Manual, 01/2015, 6FC5398-6AP40-5BA2
Universal