Figure 71. Fan installation
Step 5.
Insert the fan into the fan slot in the fan assembly bracket and press it down until it is seated
correctly in the slot and the fan connector is seated correctly in the connector on the system board.
Step 6.
Install the cover (see
Step 7.
Slide the server into the rack.
Removing a hot-swap ac power supply
Use this information to remove a hot-swap ac power supply.
When you remove or install a hot-swap power supply, observe the following precautions.
Statement 5
CAUTION:
The power control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Statement 8
"Installing the cover" on page
425).
.
Chapter 5
Removing and replacing components
463