Table of Contents
Advertisement
Figure 28: Installing DC Wires in a Terminal Block
Align the terminal block over the terminal block receptor on the switch.
6.
Insert the terminal block and press it in until it is flush with the terminal block receptor.
7.
Tighten the screws on the terminal block to secure it to the terminal block receptor.
8.
If there is no gap between the terminal block and the terminal receptor, the terminal block
is seated correctly.
Figure 29: Securing a Terminal Block to a Receptor
2.8 RESET BUTTON
Reset configuration to factory default:
Press and hold Reset button for 5 seconds.
System reboot:
Press and hold Reset button for 2 seconds.
Do NOT power off the Ethernet switch when loading default settings.
51
eWorx SE500 Series Switches
:
Advertisement
Table of Contents
