Reset Button; Figure 2.22 Installing Dc Wires In A Terminal Block; Figure 2.23 Securing A Terminal Block To A Receptor - Advantech EKI-7708 Series User Manual

5. Tighten the wire-clamp screws to secure the DC wires in place.
6. Align the terminal block over the terminal block receptor on the switch.
7. Insert the terminal block and press it in until it is flush with the terminal block
receptor.
8. Tighten the screws on the terminal block to secure it to the terminal block
receptor.
If there is no gap between the terminal block and the terminal receptor, the
terminal block is seated correctly.

Figure 2.23 Securing a Terminal Block to a Receptor

2.8

Reset Button

Reset configuration to factory default:
Press and hold Reset button for 5 seconds.
System reboot:
Press and hold Reset button for 2 seconds.
Note! Do NOT power off the Ethernet switch when loading default settings.
EKI-7708 Series User Manual
Loosening
Wire-clamp
Screws
Installing DC
Wires

Figure 2.22 Installing DC Wires in a Terminal Block

25
Securing
Wire-
clamp Screws