Reset Button - Advantech EKI-7428G Series User Manual

Make sure the power is not connected to the switch or the power converter before proceed-
ing.
1. Insert a small flat-bladed screwdriver in the V1+/V1- wire-clamp screws, and loosen the
screws.
2. Insert the negative/positive DC wires into the V+/V- terminals of PW1. If setting up
power redundancy, connect PW2 in the same manner.
3. Tighten the wire-clamp screws to secure the DC wires in place.
R 1
P W
R 2
P W

2.10. Reset Button

Reset configuration to factory default:
Press and hold Reset button for 5 seconds.
System reboot:
Press and hold Reset button for 2 seconds.
Do NOT power off the Ethernet switch when loading default settings.
Loosening
Wire-clamp
Screws
Figure 2-16. Installing DC Wires in a Terminal Block
S
WITCH
Installing DC
Wires
R 1
Securing
P W
Wire-clamp
R 2
Screws
P W
I
NSTALLATION
20