Table of Contents
Advertisement
The following table describes the items in the previous figure.
Item
Port Select
Select the port list to specify the ports that apply to this setting.
Admin Enable
Select Enabled or Disabled to setup the admin profile for the STP port.
Path Cost (0 = Auto)
Set the port's cost contribution. For a root port, the root path cost for the
bridge. (0 means Auto).
Edge Port
Click the drop-down menu to set the edge port configuration.
No: Force to false state (as link to a bridge).
Yes: Force to true state (as link to a host).
P2P MAC
Click the drop-down menu to set the Point-to-Point port configuration.
No: Force to false state.
Yes: Force to true state.
Migrate
Click the check box to enable the migrate function.
Forces the port to use the new MST/RST BPDUs, requiring the switch to test on
the LAN segment. for the presence of legacy devices, which are not able to
understand the new BPDU formats.
Apply
Click Apply to save the values and update the screen.
Table 53: L2 Switching > Spanning Tree > STP Port Settings
STP Bridge Settings
The STP Bridge Settings page allows you to configure the priority, forward delay, maximum age,
Tx hold count, and the hello time for the bridge.
To access this page, click L2 Switching > Spanning Tree > STP Bridge Settings.
110
eWorx SE500 Series Switches
Description
:
Advertisement
Table of Contents
