Table of Contents
Advertisement
Figure 14: Attaching a Fiber Optic Cable to a Transceiver
Repeat the previous procedures to install any additional SFP transceivers in the switch.
8.
The fiber port is now set up.
2.4.2 REMOVING SFP MODULES
To disconnect an LC connector, use the following guidelines:
Press down and hold the locking clips on the upper side of the optic cable.
1.
Pull the optic cable out to release it from the transceiver.
2.
Figure 15: Removing a Fiber Optic Cable to a Transceiver
Hold the handle on the transceiver and pull the transceiver out of the slot.
3.
42
eWorx SE500 Series Switches
:
Advertisement
Table of Contents
