Table of Contents
Advertisement
Figure 75: L2 Switching > Loopback Detection > Global Settings
The following table describes the items in the previous figure.
Item
State
Select Enabled or Disabled to setup the loopback mode.
Interval
Enter the variable in seconds (1 to 32767) to set the interval at which frames are
transmitted.
Recover Time
Enter the variable in seconds (60 to 1000000) to define the delay before
recovery.
Apply
Click Apply to save the values and update the screen.
Table 64: L2 Switching > Loopback Detection > Global Settings
Port Settings
The Port Settings page allows you to select ports that are detected by the loopback detection
function and configure their status (enabled or disabled).
To access this page, click L2 Switching > Loopback Detection > Port Settings.
121
eWorx SE500 Series Switches
Description
:
Advertisement
Table of Contents
