Table of Contents
Advertisement
2.7.2 CONSIDERATIONS
Take into consideration the following guidelines before wiring the device:
The Terminal Block (CN1) is suitable for 12-24 AWG (3.31 - 0.205 mm
in.
The cross sectional area of the earthing conductors shall be at least 3.31 mm
Calculate the maximum possible current for each power and common wire. Make sure the
power draw is within limits of local electrical code regulations.
For best practices, route wiring for power and devices on separate paths.
Do not bundle together wiring with similar electrical characteristics.
Make sure to separate input and output wiring.
Label all wiring and cabling to the various devices for more effective management and
servicing.
Routing communications and power wiring through the same conduit may cause signal interference. To
avoid interference and signal degradation, route power and communications wires through separate
conduits
2.73 GROUNDING THE DEVICE
Do not disconnect modules or cabling unless the power is first switched off.
The device only supports the voltage outlined in the type plate. Do not use any other power
components except those specifically designated for the switch device.
Before connecting the device properly ground the device. Lack of a proper grounding setup may result
in a safety risk and could be hazardous.
Do not service equipment or cables during periods of lightning activity.
Do not service any components unless qualified and authorized to do so.
Do not block air ventilation holes.
47
eWorx SE500 Series Switches
2
). Torque value 7 lb-
2
.
:
Advertisement
Table of Contents
