Table of Contents
Advertisement
Position the SFP transceiver with the handle on top, see the following figure.
2.
Locate the triangular marking in the slot and align it with the bottom of the transceiver.
3.
Insert the SFP transceiver into the slot until it clicks into place.
4.
Make sure the module is seated correctly before sliding the module into the slot.
5.
A click sounds when it is locked in place.
Figure 13: Installing an SFP Transceiver
If you are attaching fiber optic cables to the transceiver, continue with the following step.
Otherwise, repeat the previous steps to install the remaining SFP transceivers in the device.
Remove the protective plug from the SFP transceiver.
6.
Do not remove the dust plug from the transceiver if you are not installing the fiber optic cable
at this time. The dust plug protects hardware from dust contamination.
Insert the fiber cable into the transceiver. The connector snaps into place and locks.
7.
41
eWorx SE500 Series Switches
:
Advertisement
Table of Contents
