Figure 2.7 Installing An Sfp Transceiver; Figure 2.8 Attaching A Fiber Optic Cable To A Transceiver - Advantech EKI-7710E-2C User Manual

5. Make sure the module is seated correctly before sliding the module into the slot.
A click sounds when it is locked in place.
If you are attaching fiber optic cables to the transceiver, continue with
Note!
the following step. Otherwise, repeat the previous steps to install the
remaining SFP transceivers in the device.
6. Remove the protective plug from the SFP transceiver.
Do not remove the dust plug from the transceiver if you are not installing
Note!
the fiber optic cable at this time. The dust plug protects hardware from
dust contamination.
7. Insert the fiber cable into the transceiver. The connector snaps into place and
locks.

Figure 2.8 Attaching a Fiber Optic Cable to a Transceiver

8. Repeat the previous procedures to install any additional SFP transceivers in the
switch.
The fiber port is now setup.
EKI-7710 Series User Manual

Figure 2.7 Installing an SFP Transceiver

17
Handle