Removing Sfp Modules; Figure 2.8 Installing An Sfp Transceiver; Figure 2.9 Attaching A Fiber Optic Cable To A Transceiver - Advantech EKI-8500 Series User Manual

5. Make sure the module is seated correctly before sliding the module into the slot.
A click sounds when it is locked in place.
Note! If you are attaching fiber optic cables to the transceiver, continue with
the following step. Otherwise, repeat the previous steps to install the
remaining SFP transceivers in the device.
6. Remove the protective plug from the SFP transceiver.
Note!
Do not remove the dust plug from the transceiver if you are not installing
the fiber optic cable at this time. The dust plug protects hardware from
dust contamination.
7. Insert the fiber cable into the transceiver. The connector snaps into place and
locks.

Figure 2.9 Attaching a Fiber Optic Cable to a Transceiver

8. Repeat the previous procedures to install any additional SFP transceivers in the
switch.
The fiber port is now setup.
2.4.2

Removing SFP Modules

To disconnect an LC connector, use the following guidelines:
1. Press down and hold the locking clips on the upper side of the optic cable.

Figure 2.8 Installing an SFP Transceiver

16
Handle
EKI-8500 Series User Manual