Loopback Detection; Figure 4.56 L2 Switching > Loopback Detection > Global Settings - Advantech EKI-9226G Series User Manual

4.5.13

Loopback Detection

The Loopback Detection function is used to detect looped links. By sending detection
frames and then checking to see if the frames returned to any port on the device, the
function is used to detect loops.
4.5.13.1 Global Settings
The Global Settings page allows you to configure the state (enabled or disabled) of
the function, select the interval at which frames are transmitted and the delay before
recovery.
To access this page, click L2 Switching > Loopback Detection > Global Settings.
Figure 4.56 L2 Switching > Loopback Detection > Global Settings
The following table describes the items in the previous figure.
Item
State
Interval
Recover Time
Apply
The ensuing table for Loopback Detection Global Information settings are infor-
mational only: State, Interval and Recover Time.
Description
Select Enabled or Disabled to setup the loopback mode.
Enter the variable in seconds (1 to 32767) to set the interval at which
frames are transmitted.
Enter the variable in seconds (60 to 1000000) to define the delay
before recovery.
Click Apply to save the values and update the screen.
68 EKI-9226G Series User Manual