Figure 4.76 L2 Switching > Spanning Tree > Stp Port Settings - Advantech EKI-7712 Series User Manual

To access this page, click L2 Switching > Spanning Tree > STP Port Settings.
Figure 4.76 L2 Switching > Spanning Tree > STP Port Settings
The following table describes the items in the previous figure.
Item
Port Select
Admin Enable
Path Cost (0 = Auto) Set the port's cost contribution. For a root port, the root path cost for
Edge Port
P2P MAC
Migrate
Apply
The ensuing table for STP Port Status settings are informational only: Port, Admin
Enable, Path Cost, Edge Port and P2P MAC.
4.5.10.3 STP Bridge Settings
The STP Bridge Settings page allows you to configure the priority, forward delay,
maximum age, Tx hold count, and the hello time for the bridge.
Description
Select the port list to specify the ports that apply to this setting.
Select Enabled or Disabled to setup the admin profile for the STP
port.
the bridge. (0 means Auto).
Click the drop-down menu to set the edge port configuration.
No: Force to false state (as link to a bridge).

 Yes: Force to true state (as link to a host).
Click the drop-down menu to set the Point-to-Point port configuration.
 No: Force to false state.
Yes: Force to true state.

Click the check box to enable the migrate function.
Forces the port to use the new MST/RST BPDUs, requiring the switch
to test on the LAN segment. for the presence of legacy devices, which
are not able to understand the new BPDU formats.
Click Apply to save the values and update the screen.
70 EKI-7720 Series User Manual