Connecting The Machine; Connecting To The Interfaces; Connecting To The Ethernet Interface - Ricoh C9020L Operating Instructions Manual

2. Connecting the Machine

This chapter describes how to connect the machine to the network and specify the network settings.

Connecting to the Interfaces

This section explains how to identify the machine's interface and connect the machine according to the
network environment.
• A network interface cable with a ferrite core must be used for RF interference suppression.
1. USB Host Interface
Port for connecting the USB cable. It is used to connect device such as a digital camera to this machine.
2. USB 2.0 port
Port for connecting the USB2.0 interface cable.
3. 10BASE-T/100BASE-TX port
Port for connecting the 100BASE-TX or 10BASE-T cable.

Connecting to the Ethernet Interface

This section describes how to connect Ethernet interface cable to the Ethernet interface.
• If the main power switch is on, turn it off.
• Use the following Ethernet cables.
• Unshielded Twisted Pair Cable (UTP) or Shielded Twisted Pair Cable (STP) and Category type
5 or more
1
2
3
BKU003S
2
51