Detecting Blank Sheet - Ricoh C9020L Operating Instructions Manual

• If a multi-page feed or paper jam occurs, the originals are not sent properly and not stamped. If you
find a page that is not stamped, send only that page again.
• You can have the machine select the Stamp function right after the power is turned on or whenever
the [Clear Modes] key is pressed. See "Setting Transmission Function Defaults (Home Position)".
• A paper jam during Parallel Memory Transmission may cause the transmission to fail even if stamping
is performed.
• You cannot turn the Stamp function on or off while an original is being scanned.
• p.77 "Setting Transmission Function Defaults (Home Position)"
• p.151 "General Settings/Adjust"

Detecting Blank Sheet

Upon completion of the first page scanning, an alarm sounds if the page is nearly blank.
• The blank sheet-detecting function works only when an original is scanned using the ADF.
• The blank sheet-detecting function is ineffective for second and subsequent pages.
This function notifies you if an original is placed wrong side down on the scanner. When this happens, a
message appears for a few seconds. The message differs depending on the number of pages to be scanned
and transmission mode.
• When sending a document using Immediate Transmission or when all pages have been scanned in
Memory Transmission:
• When some pages are left unscanned in Parallel Memory Transmission or Memory Transmission:
• Even if a near blank sheet is detected, it is transmitted as normal.
• You can turn this function on or off with the User Parameter (switch 11, bit 2) in the Fax Features menu.
See "Parameter Settings".
Placing Originals
1
33