Ricoh C9020L Operating Instructions Manual page 839

Message
no smart card detected on device
Open log file <file name>
Printer <printer name> has no queue
Printer queue <print queue name> cannot be
serviced by printer 0, <print server name>
Print server <print server name> has no printer
Print sessions full
Required file server (<file server name>) not found The required file server <file server name> is not
sap enable. saptype=<SAP type>, sapname=<SAP
name>
server certificate invalid
server identity invalid
server not trusted
session IPv4 <community name> not defined.
session IPv6 <community name> not defined.
session_IPX <community name> not defined.
Problem and solutions
PEAP/GTC (Generic Token Card) is selected, but
a smart card using GTC authentication cannot be
found.
The specified log file has been opened when the
print server is active.
The print queue is not assigned to the printer when
the print server is active. Assign the print queue to
the printer using NetWare administrator account,
and then restart the printer.
The print queue cannot be established when the
print server is active. Make sure that print queue
exists on the specified file server.
The printer is not assigned to the print server when
the print server is active. Use the NetWare
administrator account to assign the printer, and
then restart the printer.
No more print jobs can be accepted. Wait a while
before making a print job again.
found.
The SAP function has been started. The SAP packet
is issued to advertise the service on the SAP table
on the NetWare server.
The server ID is disabled. Check the server
authentication.
The server ID is disabled. Check the server
authentication.
The RADIUS server cannot be trusted.
The requested community name is not defined.
The requested community name is not defined.
The requested community name is not defined.
Message List
4
169