Ssdp; Ssh - Ricoh C9020L Operating Instructions Manual

4. Monitoring and Configuring the Printer
Interval configuration
msh> sntp interval "polling_time"
• You can specify the interval at which the printer synchronizes with the operator-specified NTP
server. The default is 60 minutes.
• The interval can be entered from 0, or between 15 and 10,080 minutes.
• If you set 0, the printer synchronizes with the NTP server only when you turn the printer on. After
that, the printer does not synchronize with the NTP server.
Time-zone configuration
msh> sntp timezone "±hour_time"
• You can specify the time difference between the printer clock and NTP server clock. The values
4
are between -12:00 and +13:00.
• You can only select either the address or host name for the ntp server.

ssdp

Use the "ssdp" command to view and configure SSDP settings.
View settings
msh> ssdp
Setting effective time
msh> ssdp profile [1801-86400]
The default is 10800 seconds.
Advertise packet TTL settings
msh> ssdp ttl [1-255]
The default is 4.

ssh

Use the "ssh" command to view and configure SSH settings.
View settings
msh> ssh
Data compression communication settings
msh> ssh compression {on|off}
The default is "on".
136