Ricoh C9020L Operating Instructions Manual page 842

4. Monitoring and Configuring the Printer
The print server received error <error number>
during attempt to log in to the network. Access to
the network was denied. Verify that the print server
name and password are correct.
too many pictures.
trap account is unavailable.
4
unauthenticated
Updated (option name)(value) via DHCPv6 Server The parameter obtained from the DHCP server has
usbd is disabled.
waiting for keys
WINS name registration: No response to server
(WINS server address)
WINS wrong scope ID=<scope ID>
write error occurred. (diskfull)
write error occurred. (fatal)
172
Message Problem and solutions
Login to the file server failed when the print server
is active. The print server is not registered or a
password is specified. Register the print server
without specifying a password.
PictBridge printing failed because too many image
are sent during one print transaction. Reduce
images at one print transaction.
v3Trap cannot be sent. This could be because the
Trap destination account is different from the
account specified by the printer.
The authentication failed. The supplicant was
denied access to the access point, or was not
authenticated.
been updated.
Plug and Play function and printing is disabled
because usbd is disabled in the security mode.
Enable usbd in the security mode.
The supplicant is waiting for the session key.
There was no response from the WINS server.
Check the correct WINS server address is entered.
Alternatively, check the WINS server is functioning
properly.
An invalid scope ID was used. Use a valid scope
ID.
Diskfull error occurred while writing the spool file.
Wait for the print job to progress and available
HDD space increases. Only the pages that have
been spooled when the error occurred are printed.
Diskfull error occurred while writing the spool file.
Wait for the print job to progress and available
HDD space increases. The print job that was being
spooled when the error occurred is not printed.