5.3
Parameterizing the device
5.3.1
Procedure
To commission the device, you must specify the operating parameters listed below in the device
settings:
• Basic parameters
The following settings are also useful:
• Language
• Date/time
• Device protection against tampering
5.3.2
First start-up
Select the required language and confirm your selection.
5.3.3
Basic parameters
Set the basic parameters:
• Connection type
• Voltage
– Direct measurement on the system or using voltage transformers
– Measuring input voltage in the case of direct measurement on the system
– Primary and secondary voltage when measuring using voltage transformers
• Current
– Primary current
– Secondary current
Please also note the information in chapters Operation (Page 65) and Parameterizing
(Page 79).
PAC4220
Equipment Manual, L1V30827278B-01
Commissioning
5.3 Parameterizing the device
59