Staple Positions; Media Sizes That Allow Stapling - Lexmark X95 series Service Manual

Hide thumbs Also See for X95 series:

Table of Contents

Staple positions

There are four stapling modes:

• Front staple (corner) [front corner]

The stapler staples a set of media obliquely (45 degrees) after the rear tamper

aligns the media to the front side.

• Rear staple (corner) [rear corner]

This type of stapling is applied for media with a width of 216 mm or more.

The stapler moves to the rear corner and staples a set of media obliquely (45

degrees) after the front tamper aligns the media to the rear side.

• Rear Staple (Straight) [rear straight]

This type of stapling is applied for media with a width of less than 216 mm.

The Stapler staples a set of media in parallel with the media edge after the front

tamper aligns the media to the rear side.

• Dual Staple [dual]

The Stapler staples a set of media at fixed positions (front/rear sides) in parallel

with the media edge after the front tamper aligns the media to the specified position

for each media size.

Media size that allows stapling depends on stapling positions.

Process direction

Process direction

Process direction

Process direction

Diagnostic aids