Media Eject Unit Assembly Removal - Lexmark X95 series Service Manual

7558-xxx
Remove the three screws securing the media eject motor assembly (A).
5.
Remove the media eject motor assembly (A).
6.
7. Remove any remaining harnesses from the clamps.

Media eject unit assembly removal

1. Remove the finisher front door assembly. See
Remove the rear upper cover. See
2.
3. Remove the upper media bin assembly. See
Remove the upper media bin vertical cover. See
4.
Remove the two media eject unit springs (A) by pushing them downward.
5.
6. Disconnect the connector from the eject unit solenoid (B).
Release the harness from the two clamps.
7.
Right
Service Manual
4-370
"Finisher front door assembly removal" on page
"Rear upper cover removal" on page
"Upper media bin assembly removal" on page
Harness clamp
A
B
A
Connector
Rear
4-380.
"Right eject cover removal" on page
Connector
A
Previous
Next
Go Back
4-348.
4-422.
4-381.