Staple Positions; Media Sizes That Allow Stapling - Lexmark X95x series Service Manual

7558-xxx

Staple positions

There are four stapling modes:
• Front staple (corner) [front corner]
The stapler staples a set of media obliquely (45 degrees) after the rear tamper
aligns the media to the front side.
• Rear staple (corner) [rear corner]
This type of stapling is applied for media with a width of 216 mm or more.
The stapler moves to the rear corner and staples a set of media obliquely (45
degrees) after the front tamper aligns the media to the rear side.
• Rear Staple (Straight) [rear straight]
This type of stapling is applied for media with a width of less than 216 mm.
The Stapler staples a set of media in parallel with the media edge after the front
tamper aligns the media to the rear side.
• Dual Staple [dual]
The Stapler staples a set of media at fixed positions (front/rear sides) in parallel
with the media edge after the front tamper aligns the media to the specified position
for each media size.

Media sizes that allow stapling

Media size that allows stapling depends on stapling positions.
Service Manual
3-96
Previous
Rear
Next
Go Back
Process direction
Front
Rear
Process direction
Front
Rear
Process direction
Front
Rear
Process direction
Front