Table of Contents
Advertisement
Make sure the media eject unit assembly properly actuates the switch (eject cover interlock) (H) without
•
binding.
Media entrance pinch guide assembly removal
1.
Open the finisher front door assembly.
Remove the rear upper cover. See
2.
Remove the left lower cover. See
3.
Remove the left upper cover. See
4.
Remove the screw securing the cover (A) to the media entrance pinch guide assembly (B).
5.
6.
Remove the cover (A).
Disconnect the connector from the sensor (finisher media entrance) (C).
7.
Release the harness from the clamps.
8.
Remove the three screws securing the media entrance pinch guide assembly (B).
9.
Connector
C
10.
Remove the entrance pinch guide assembly (B) from the finisher.
Right
Actuator
"Rear upper cover removal" on page
"Left lower cover removal" on page
"Left upper cover removal" on page
B
Clamp
Left
H
G
4-380.
4-359.
4-360.
A
Rear
7558-xxx
Left
B
Repair information
4-373
Previous
Next
Go Back
Advertisement
Table of Contents
