Sensor (Image Calibration) Removal - Lexmark X95 series Service Manual

If the Web page cannot be accessed, or an error persists despite trying to boot in Invalid Engine code mode,
then there is no way to backup the eSF apps. The technician needs to make the customer aware that the
applications and their setting could not be saved.
Note: There is a size limit on the export file - 128kb. Because of this, it is recommended that you don't use
the "global" backup found in Settings --> Import/Export --> Export Shortcuts File, Export Settings File,
Export Embedded Solutions Settings File and Export Security Setups File. Customers with a large
number of applications or settings may exceed the file size limit and have information truncated in the
exported file.

Sensor (image calibration) removal

Remove the printer front door. See
1.
Remove the transfer belt cleaner. See
2.
Remove the waste toner box.
3.
4. Remove the four photoconductor units.
Remove the four toner supplies.
5.
Remove the operator panel front cover. See
6.
Remove the printhead retract door. See
7.
Remove the inner cover. See
8.
9. Remove the inner plate. See
Remove the waste toner add chute. See
10.
Remove the front left cooling fan. See
11.
Disconnect the cable (A) from the sensor (image calibration).
12.
Remove the screw (B) from the sensor (image calibration).
13.
"Printer front door removal" on page
"Transfer belt cleaner removal" on page
"Printhead retract door removal" on page
"Inner cover removal" on page
"Inner plate removal" on page
"Front left cooling fan removal" on page
A B
"Operator panel front cover (MFP) removal" on page
4-4.
4-98.
"Waste toner auger chute removal" on page
7558-xxx
4-13.
4-178.
4-8.
4-145.
4-194.
4-78.
Repair information
4-153
Previous
Next
Go Back