Table of Contents
Advertisement
7558-xxx
HCF separation roll shaft assembly removal
Remove the HCF media tray assembly. See
1.
2.
Remove the HCF media feed unit assembly. See
Remove the HCF feed lift motor. See
3.
Remove the HCF feed lift gear bracket. See
4.
Remove the HCF separation roll assembly. See
5.
page
4-445.
Remove the four screws securing the separation roll shaft assembly (A) to the media feed unit assembly
6.
(B).
Remove the separation roll shaft assembly (A).
7.
Note: The HCF media feed unit assembly (B) becomes detached from the separation roll shaft assembly
(A) at the hinge point.
Note: Before re-installing the separation roll shaft assembly (A), ensure the HCF media feed unit assembly (B)
is re-attached at the two hinge points.
HCF top cover removal
Pull out the HCF media tray.
1.
2.
Remove the four screws securing the HCF top cover (B).
Service Manual
4-446
"HCF media tray assembly removal" on page
"HCF feed unit removal" on page
"HCF feed lift motor removal" on page
"HCF feed lift gear bracket removal" on page
"HCF separation roll assembly removal" on
B
A
4-436.
4-432.
4-430.
4-430.
Previous
Next
Go Back
Advertisement
Table of Contents
