Table of Contents
Advertisement
Fax Storage Location
This setting determines the location where faxes will be saved.
To change this setting:
From the Configuration Menu, navigate to Fax Storage Location.
1.
Select the location where faxes will be saved.
2.
Touch Submit to save the setting, or touch Back to return to the Configuration Menu without saving any
3.
changes.
FB Edge Erase
The value of this setting determines the size in millimeters of the "no-print" zone around a flatbed scan job.
To change this setting:
1.
From the Configuration Menu, navigate to FB Edge Erase.
Touch
2.
Touch Submit to save the setting, or touch Back to return to the Configuration Menu without saving any
3.
changes.
Font Sharpening
This setting allows a user to set a text point-size value from 0 to 150. For all font sizes in a print job equal or
below the text point-size value set, the high frequency screens will be used. For example, if this setting's value is
"24" then all fonts sized 24 points or less will use the high frequency screens. The panel displays a numeric
keypad interface to allow the user to adjust this setting's value.
To change this setting:
From the Configuration Menu, navigate to Font Sharpening.
1.
Touch
2.
Touch Submit to save the setting, or touch Back to return to the Configuration Menu without saving any
3.
changes.
This setting only affects the following emulators: PostScript, PCL, PDF, XL, and XPS.
Format Fax Storage
This setting when executed, deletes faxes that are stored in the location based on the value of the Fax Storage
Location setting. Upon completion of the operation, the screen returns to the Configuration Menu.
To run this setting:
From the Configuration Menu, navigate to Format Fax Storage.
1.
The screen displays Contents will be lost. Continue?.
2.
Touch Yes to format the fax storage, or touch No to cancel the operation and return to the Configuration
3.
Menu without saving any changes.
Jobs on Disk
This setting is for clearing jobs that remain on the disk due to buffering.
To perform this function:
From the Configuration Menu, navigate to Jobs on Disk.
1.
Touch Do Not Delete or Delete.
2.
or
to change the setting.
or
to change the value.
7558-xxx
Previous
Go Back
Diagnostic aids
3-11
Next
Advertisement
Table of Contents
