Waste Toner Shaft Gate Removal - Lexmark X95 series Service Manual

Remove the harness clamp (D) from the waste toner sensor guide.
6.
7. Remove the waste toner sensor guide.

Waste toner shaft gate removal

Remove the printer front door. See
1.
Remove the transfer belt cleaner. See
2.
3. Remove the waste toner box.
Remove the four photoconductor units.
4.
Remove the four toner supplies.
5.
Remove the operator panel front cover. See
6.
7. Remove the printhead retract door. See
Remove the inner cover. See
8.
Remove the ATC sensor PCB bracket. See
9.
Remove the waste toner add chute. See the
10.
Remove the printer right side cover. See
11.
12. Remove the LVPS subfan guide. See
Remove the waste toner sensor guide. See
13.
Remove the LVPS PCBA. See the
14.
Remove the main power GFI interface. See the
15.
Remove the PC/developer drive motor. See the
16.
17. Remove the waste toner agitator motor. See the
"Printer front door removal" on page
"Transfer belt cleaner removal" on page
"Operator panel front cover (MFP) removal" on page
"Printhead retract door removal" on page
"Inner cover removal" on page
"ATC sensor PCB bracket removal" on page
"Waste toner auger chute removal" on page
"Printer right cover removal" on page
"LVPS front fan guide removal" on page
"Waste toner sensor guide removal" on page
"LVPS PCBA removal" on page 4-112
"Main power GFI interface removal" on page
"PC/developer drive motor removal" on page
"Waste toner agitator motor removal" on page
4-13.
4-178.
4-145.
4-4.
4-14.
4-111.
Repair information
7558-xxx
Previous
Next
Go Back
4-8.
4-29.
4-194.
4-196.
4-119.
4-138.
4-191.
4-197