Cancelling a Setting
If you set multiple copy functions at the same time, you may not be able to use these functions depending on the combination. In such a
case, a message is displayed.
For example, if [Margin] is specified, [N-in-1] and [Repeat] cannot be set.
Cancel the setting of a function with low priority among the ones that are displayed in the message, and then set the function you want
to use again. Some functions cannot be used in combination with other functions.
To cancel the setting of any function, reset the setting to the default setting.
Memo
If you change the default value from the factory default setting, select the default value after the change.
Administrator Setup
1.
Press
(COPY).
2.
Press
to display the [Change Settings] menu.
3.
Press
to select the function to cancel, and then press
4.
Press
to select the initial value, and then press
5.
Press
until the top screen is displayed.
(OK).
(OK).
48