Adjusting the Density When Faxing
This section describes how to change the default setting of the density when faxing. You can adjust the density in seven levels.
1.
Press
(SETTING).
2.
Press to select [Admin Setup], and then press
3.
Enter the administrator password.
The factory default password is "aaaaaa".
4.
Select [Enter], and then press
5.
Press to select [Fax Setup], and then press
6.
Press to select [Default Settings], and then press
7.
Press
to select [Density], and then press
8.
Press
or
Memo
[0] is the standard value. To increase the density, select [+1], [+2], or [+3] (darkest). To decrease the density, select [-1], [-2], or
[-3] (lightest).
(OK).
to select a density, and then press
(OK).
(OK).
(OK).
(OK).
(OK).
725