Changing the Sender Name That is Printed on Faxes
[TTI] is enabled by factory default, resulting in the name that you specify with [Sender ID] printed on faxes as [Standard TTI]. To use
any sender name (originator) other than [Standard TTI], follow the procedure below.
1.
Press
(FAX).
2.
Set a document in the ADF or on the document glass.
3.
Check that [Fax] is selected, and then press
4.
Press
to select [Fax Functions], and then press
5.
Press
to select [TTI Select], and then press
To select an originator, you must register the sender name (originator) in advance.
Editing the Sender Name (Originator)
6.
Press
to select an originator name, and then press
7.
Press
until the start screen is displayed.
8.
Specify a destination.
Specify a destination in one of the following ways.
Using Direct Entry
Selecting from the Phone Book
Using a One-touch Key
Selecting from the Transmission History and Reception History
9.
Press
(START).
Transmission starts.
Topics
Disclosing a Sender Name (Originator) to the Recipient
You can change other settings for fax transmissions.
Setting Scanning for Transmission
Sending a Fax
(OK).
(OK).
(OK).
(OK).
298