Setting Scan To Pc - Oki MB472dn User Manual

6.
Click [OK].

Setting Scan to PC

To perform Scan to PC, you must register the computer name, IP address, and port number to the machine.
1.
Click [Start], and then select [All Programs] > [Okidata] > [ActKey] > [Tools] > [Network
Configuration].
2.
Right-click [ActKey] in the task tray.
3.
Click [Show Network Configuration].
4.
Select [Properties] from the [Scanner] menu.
5.
Click the [Register] tab.
After installing the scanner driver, start Network Configuration, and then select a driver to use. Select [Properties] from the [Scanner]
menu, and then select the [Register] tab. As the computer information, the computer name, IP address and port number are displayed.
You do not need to set the computer name, because the computer's host name is automatically acquired.
Although the setting value of the computer's IP address is automatically displayed, if multiple network cards are installed in the
computer, multiple IP addresses are displayed. Select the IP address of the network card that is currently used. Change the current
setting for the port number that is displayed if necessary.
After all settings are complete, click the [Register] button to register the setting to the machine.
If the machine is turned off and cannot be connected, an error occurs when registering. After registering, if the computer's name, IP
address or port number is changed, you must register again by following the procedure above.
138