Engine Disassembly / Inspection - Bottom End; Stator Cover Removal / Inspection - Polaris ACE 900 2017 Service Manual

ENGINE DISASSEMBLY / INSPECTION - BOTTOM END

STATOR COVER REMOVAL / INSPECTION

NOTICE
The stator cover can be removed with the engine
installed in the chassis.
1. Remove the thirteen screws retaining the stator
cover.
CAUTION
The flywheel contains powerful magnets. Use caution
when removing and installing the stator cover. DO NOT
place fingers between cover and crankcase at any time
during the removal / installation process or injury could
result.
9929422 R02 - 2017-2019 ACE 900 Service Manual
© Copyright Polaris Industries Inc.
ENGINE / COOLING SYSTEM
2. Carefully pry the stator cover off the engine using the
two pry areas as shown below.
3. Inspect the condition of the stator windings
w
output wires . If replacement is required, refer to
Chapter 10.
4. Inspect the ball bearing that supports the starter
motor shaft.
3
q
and
3.51