Stator Removal; Starter One-Way Clutch Inspection - Polaris RANGER ETX 2015 Owner's Manual

STATOR REMOVAL

NOTE
Test stator wire continuity before removing it from the
housing.
1. Remove the stator cover.
CAUTION
The flywheel contains powerful magnets. Use caution
when removing the stator cover.
DO NOT place fingers between cover and crankcase at
any time during the removal process or injury could
result.
2. Remove and discard the stator cover gasket.
CAUTION
Be sure engine coolant does not contaminate the
engine oil during stator cover service.
e
3. Remove the 3 bolts that secure the stator
w
stator cover .
4. Remove the 2 bolts that secure the stator wire
r
routing bracket to the stator cover.
q
5. Remove the stator from the stator cover.

STARTER ONE-WAY CLUTCH INSPECTION

1. Remove flywheel as outlined in this chapter.
2. Place flywheel on work bench. Grasp gear and rotate
clockwise. It should turn smoothly without binding.
3. Rotate gear counterclockwise. The gear should
immediately lock in position and not slip.
4. Remove starter gear from the flywheel assembly.
9926806 R03 - 2015 - 2016 RANGER ETX / 570 2-SEAT 2015 - 2016 RANGER 570 CREW Service Manual
© Copyright Polaris Industries Inc.
5. Inspect surface of flywheel gear hub
galling, or uneven surface.
6. Inspect crankshaft bearing surface for abnormal
wear.
w
7. Remove the
q
to the
8. Remove clutch
r
rollers and roller contact surface
wear, damage, or uneven surface.
ENGINE / COOLING SYSTEM
q
for wear,
one-way clutch retaining bolts.
e
and inspect both sides of drive
t
inside hub for
3
3.73