Power Options - Symbol Spectrum24 AP-4100 Series Product Reference Manual

Hardware Installation
The standard antenna performs well in most office environments. Obtain
additional or higher-performance antennas from Symbol Technologies, Inc.
Contact Symbols representative to order the following models.
•
•
•
•
If installing two antennas, enable the Antenna Selection in the User Interface
found in section 2.3: "Access Point Installation" on page 56.
4.5

Power Options

Power options are as follows:
•
•
A Symbol BIAS-T system can also be used to combine low-voltage DC with
Ethernet data in a single cable connecting to an access point. For
information on the BIAS-T system, go to (www.symbol.com) and search for
the BIAS-T low power distribution system.
176
standard rubber antenna
single high-performance antenna
twin high-performance diversity antennas
mountable F-plane antenna
Standard 24 volt, 1 amp power
supply115/230VAC, 50/60Hz.
US line cord.
Part Number: 50-24000-024
Part Number: 23844-00-00
AP-4100 Series Access Point Product Reference Guide