Table of Contents
Advertisement
Configuring the AP
Administration screens include options for saving or clearing data that
appear on the bottom line of the screen. Confirmation prompts include
the following:
OK
Save
Save ALL APs
Cancel
2.2.1
Entering Admin Mode
The UI defaults to User when in Serial mode allowing read-only access to the
APs functions (e.g., view statistics). Entering Admin mode provides access to
configuration menus and allows the user to configure the AP .
Entering Admin mode requires the administration password.
1. Select
2. Type the default password:
The password is case-sensitive.
52
Registers settings but does not save them in NVM
(nonvolatile memory). A reset command returns to
previously saved settings.
Saves all settings (including ones not on that screen) to
NVM. This is the same as Save Configuration in the Special
Functions screen.
Saves the AP installation configuration information to all APs
with the same Net_ID (ESS)
configuration changes for the current AP on the Known APs
table to update their configuration and reset after the
configuration has been modified. Users can perform this
option only among the same hardware platforms and same
firmware versions.
Does not register settings changed in a screen.
Enter Admin Mode
administration password:
Enter System Password:
Symbol
from the Main Menu. The AP prompts for the
AP-4100 Series Access Point Product Reference Guide
This option saves the
.
Advertisement
Table of Contents
