Table of Contents
Advertisement
Installing and Configuring Kerberos Setup Service
4. Enter the AP access range set the time and status information using the
5. Set the SNMP Setting.
6. Click
E.5 Implementing Kerberos without the KSS
Kerberos support is available for the AP-4131 access point without the use of
the KSS. This configuration requires Windows 2000 Server with SP2.
To configure Kerberos support without the KSS:
1. Install Active Directory, making the server a domain controller (preferably
2. Enable DNS if no other DNS server is available on the network.
3. Enable network time services (Daytime or SNTP) on this server or another
4. Create user accounts for the access points and Kerberos Clients. The
5. After creating each account, right-click on an account and click
E-14
Setup Start Time
and
Add
when all the parameters have been entered.
After the AP initializes, the AP list view window displays the
Events
(APs successful in gaining access to KSS).
a Primary Domain Controller).
Configuring an Additional Domain Controller requires the presence of a
PDC and synchronization of the user database. Choose defaults for
Domain Controller configuration if it is a PDC. Record the Domain name
as it would be needed for configuring the AP .
networked server. The same server as the KDC server can be used.
From the Windows Control Panel, click
Add/Remove Windows
Services, and select
Win2k Server CD is required to add this component.
username for the access point user account should be the same as the
access point ESSID. Therefore, only one AP user account for each WLAN
(or ESSID) is required.
properties. Click the
Pre-Authentication.
Setup Expire Time
Components, double-click
Simple TCP/IP
Services. Click
Account
tab. Select
AP-4131 Access Point Product Reference Guide
pull-down menus.
Add/Remove
Programs. Click
Networking
OK
and Next. The
Do not require Kerberos
Connection
Advertisement
Table of Contents
