Symbol Spectrum24 AP-4100 Series Product Reference Manual page 78

Configuring the AP
Manual Kerberos Authentication Configuration
The Configure Kerberos Authentication screen allows the network
administrator to change or verify the AP parameters for Kerberos
authentication. If a DHCP server is not available use the Configure Kerberos
Authentication screen to manually configure and enable Kerberos, save and
reset the AP . If an optional KSS has been installed on the Kerberos server,
resetting the AP allows the KSS to complete the Kerberos configuration and
start the Kerberos authentication services. If a DHCP server is available
enable Kerberos using DHCP server options found in section 1.3.3: "DHCP
Support" on page 16. These options can enable Kerberos on the AP , and
setup the KDC name, KSS name and port number.
Configure the AP through a direct serial connection. Disabling Kerberos
returns (Kerberos
services to their previous setting. If an AP cannot be accessed through a serial
connection and SNMP is not configured for read/write, use DHCP
option 131.
1. To access and enable the Kerberos configuration, select
70
Disabled
from the System Configuration Menu. The Configure
Kerberos-[F3]
Kerberos Authentication screen displays:
Symbol Access Point
Kerberos
KDC Server Name/IP Address krbtgt
Backup KDC Name/IP Address kdc2
Realm Name
User ID
Password
KDC Timeout
OK-[CR] Save-[F1]
Enable Kerberos
is the default setting) Telnet, SNMP , and Web
Configure Kerberos Authentication
Enabled
APFW.SYMBOL.COM
ap
*******
2
KSS Setup (Optional)-[F3]
AP-4100 Series Access Point Product Reference Guide
Configure
Cancel-[ESC]